Allied Telesis AT-S83 - Manual (Page 353)

AT-S83 Management Software Command Line Interface User’s Guide
353
TIMERS SPF
Syntax
timers spf SPF-DELAY <0-2147483647> SPF-HOLDTIME <0-
2147483647>
no timers spf SPF-DELAY <0-2147483647> SPF-HOLDTIME
<0-2147483647>
Parameters
SPF-DELAY Specifies the delay between receiving a change to the
Shortest Path First (SPF) calculation. Choose a value
between 0 and 2,147,483,647. The default value is 5
seconds.
SPF-HOLDTIME Specifies the hold time between consecutive SPF
calculations. Choose a value between 0 and
2,147,483,647. The default value is 10 seconds.
Description
Use the TIMERS SPF command to adjust route-calculation timers. This
command configures the delay time between the receipt of a topology
change and the calculation of the SPF. This command also configures the
hold time between two consecutive SPF calculations.
Use the no form of this command to return the timers to their default
values.
Command Mode
Router mode
Example
The following commands set the delay time to 5 seconds and the hold time
to 10 seconds:
switch# configure terminal
switch(config)# router ospf 100
switch(config-router)# timers spf 5 10
Related Commands
none