Allied Telesis AT-S83 - Manual (Page 137)

AT-S83 Management Software Command Line Interface User’s Guide
137
NTP AUTHENTICATE
Syntax
ntp authenticate
no ntp authenticate
Parameters
none
Description
Use the NTP AUTHENTICATE command to enable authentication of the
NTP time source. By default, this command is disabled. To disable NTP
authentication on the switch, use the no form of this command.
For instructions on how to configure NTP authentication, see “Configuring
NTP Authentication” on page 370.
Command Mode
Configuration Terminal mode
Example
The following commands enable authentication of the NTP time source:
switch#configure terminal
switch(config)#ntp authenticate
Related Commands
“NTP TRUSTED-KEY” on page 143