Allied Telesis AT-S83 - Manual (Page 193)

AT-S83 Management Software Command Line Interface User’s Guide
193
SPANNING-TREE PATH-COST
Syntax
spanning-tree path-cost <1-200000000>
no spanning-tree path-cost
Parameters
path-cost Specifies the path cost. A lower path cost indicates a
greater likelihood that the interface will become a root.
Description
Use the SPANNING-TREE PATH-COST command to assign a path cost
to an interface. Use the no form of this command to reset the command to
its default value.
Command Mode
Interface mode
Example
The following commands assigns interface 5 a path cost of 1:
switch#configure terminal
switch(config)#interface xe5
switch(config-if)#spanning-tree path-cost 1
Related Commands
none