Allied Telesis AT-S83 - Manual (Page 185)

AT-S83 Management Software Command Line Interface User’s Guide
185
SHOW CLI
Syntax
show cli
Parameters
none
Description
Use the SHOW CLI command to display the CLI tree of the Interface
command mode.
Command Mode
Interface Configuration mode
Example
The following commands display the CLI tree on interface 2:
switch#configure terminal
switch(config)#interface xe2
switch(config-if)#show cli
See below for a section of the sample output of the SHOW CLI command
displayed at the Interface mode.
+-ospf
+-A.B.C.D
+- authentication [no ip ospf (A.B.C.D|) authentication]
+- authentication-key [no ip ospf (A.B.C.D|) authentication-key]
+- cost [no ip ospf (A.B.C.D|) cost]
+- database-filter [no ip ospf (A.B.C.D|) database-filter]
+- hello-interval [no ip ospf (A.B.C.D|) hello-interval]
+- message-digest-key