Allied Telesis AT-S83 - Manual (Page 287)

AT-S83 Management Software Command Line Interface User’s Guide
287
KEY CHAIN
Syntax
key CHAIN WORD
Parameters
WORD Specifies the key chain name.
Description
Use the KEY CHAIN command to access the Keychain mode. After you
enter this mode, you can set a password for the key.
Command Mode
Configuration Terminal mode
Example
The following commands configure a key chain name of “k1” and shows
the prompt change that indicates you have entered the Key Chain mode:
switch#configure terminal
switch(config)#key chain k1
switch(config-keychain)#
Related Commands
“IP RIP AUTHENTICATION KEY-CHAIN” on page 278, “KEY” on
page 286