beautypg.com

Ip rip receive version – Allied Telesis AT-S83 User Manual

Page 282

background image

Chapter 14: Routing Information Protocol (RIP) Commands

282

IP RIP RECEIVE VERSION

Syntax

ip rip receive version 1|2

no ip rip receive version 1|2

Parameters

1

Specifies the acceptance of RIP version 1 packets.

2

Specifies the acceptance of RIP version 2 packets.

Description

Use the IP RIP RECEIVE-VERSION command to receive a specified
version of RIP packets on an interface. This command overrides the
setting of the VERSION command.

Use the no form of this command to use the setting specified with the
VERSION command.

Command Mode

Interface mode

Example

The following command configures interface 5 to receive RIP version 1
packets:

switch#configure terminal

switch(config)#interface xe5

switch(config-if)#ip rip receive version 1

Related Commands

“VERSION” on page 308

See also other documents in the category Allied Telesis Computer hardware: