Speed – Allied Telesis AT-S83 User Manual

Page 196

Chapter 9: Interface Configuration Mode Commands

196

SPEED

Syntax

no speed

Parameters

1000mfull

Specifies the interface is forced to operate at a speed of
1,000 Mbps in full duplex mode.

100mfull

Specifies the interface is forced to operate at a speed of
100 Mbps in full duplex mode.

100mhalf

Specifies the interface is forced to operate at a speed of
100 Mbps in half duplex mode.

10mfull

Specifies the interface is forced to operate at a speed of
10 Mbps in full duplex mode.

10mhalf

Specifies the interface is forced to operate at a speed of
10 Mbps in half duplex mode.

auto

Enables auto speed and duplex configuration.

Description

Use the SPEED command to set the speed and duplex mode for interface
eth0 which is labeled, “10/100/1000Base-T” on the switch. You cannot use
this command to change the speed of interfaces 1 through 8. The speed
for these interfaces is set to 10G in full duplex mode and you cannot
change this value.

Use the no form of this command to remove the interface speed.

Command Mode

Interface mode

Example

The following commands set interface eth0 to 1,000Mbps in full-duplex
mode:

switch#configure terminal