Allied Telesis AT-S83 - Manual (Page 268)

Chapter 13: Spanning Tree Protocol (STP) Commands
268
SPANNING-TREE STP ENABLE
Syntax
spanning-tree stp enable
no spanning-tree stp enable
Parameters
enable Specifies STP as the active spanning-tree protocol.
Description
Use the SPANNING-TREE STP ENABLE command to enable STP on the
switch. After you have specified STP, all subsequent spanning tree
commands apply to STP only. Use the no form of this command to disable
STP on the switch.
To make STP the active spanning tree mode and enable it on the switch,
use the SPANNING TREE MODE command.
Command Mode
Configuration Terminal mode
Example
The following commands enable STP on the switch:
switch#configure terminal
switch(config)#spanning-tree stp enable
Related Commands
“SPANNING-TREE MODE” on page 257