Allied Telesis AT-S83 - Manual (Page 269)

269
Chapter 14
Routing Information Protocol (RIP)
Commands
The Routing Information Protocol (RIP) commands set the Layer 3
protocol.
This chapter contains the following commands:
ˆ “CLEAR IP RIP ROUTE” on page 271
ˆ “DEFAULT-INFORMATION ORIGINATE” on page 273
ˆ “DEFAULT-METRIC” on page 274
ˆ “DISTANCE” on page 275
ˆ “DISTRIBUTE-LIST” on page 277
ˆ “IP RIP AUTHENTICATION KEY-CHAIN” on page 278
ˆ “IP RIP AUTHENTICATION MODE” on page 279
ˆ “IP RIP AUTHENTICATION STRING” on page 280
ˆ “IP RIP RECEIVE-PACKET” on page 281
ˆ “IP RIP RECEIVE VERSION” on page 282
ˆ “IP RIP SEND-PACKET” on page 283
ˆ “IP RIP SEND VERSION” on page 284
ˆ “IP RIP SPLIT-HORIZON” on page 285
ˆ “KEY” on page 286
ˆ “KEY CHAIN” on page 287
ˆ “MAXIMUM-PREFIX” on page 288
ˆ “NEIGHBOR” on page 289
ˆ “NETWORK” on page 290
ˆ “OFFSET-LIST” on page 291
ˆ “PASSIVE-INTERFACE” on page 293
ˆ “RECV-BUFFER-SIZE” on page 294
ˆ “REDISTRIBUTE CONNECTED” on page 295
ˆ “ROUTE” on page 297
ˆ “ROUTER RIP” on page 298
ˆ “SHOW IP PROTOCOLS RIP” on page 300
ˆ “SHOW IP RIP” on page 301
ˆ “SHOW IP RIP DATABASE” on page 303