Allied Telesis AT-S83 - Manual (Page 252)

Chapter 13: Spanning Tree Protocol (STP) Commands
252
SPANNING-TREE ERRDISABLE-TIMEOUT
Syntax
spanning-tree errdisable-timeout enable|interval
Parameters
enable Enables the timeout mechanism for the interface to be re-
enabled.
interval Specifies an interval of time after which the interface is
enabled. The default is 300 seconds.
Description
Use the SPANNING-TREE ERRDISABLE-TIMEOUT command to enable
the errdisable-timeout facility, which sets a timeout for interfaces that are
disabled due to the BPDU guard feature. By default, the interface is
enabled after 300 seconds.
The BPDU guard feature shuts down the interface on receiving a BPDU
on a BPDU-guard enabled interface. This command associates a timer
with the feature such that the interface is enabled automatically without
manual intervention after a set interval. This interval can be configured by
the user using the bridge spanning-tree errdisable-timeout interval
command.
Command Mode
Configuration Terminal mode
Example
The following commands enable the errdisable-timeout facility:
switch#configure terminal
switch(config)#spanning-tree errdisable-timeout enable
Related Commands
none