Allied Telesis AT-S83 - Manual (Page 258)

Chapter 13: Spanning Tree Protocol (STP) Commands
258
SPANNING-TREE MST CONFIGURATION
Syntax
spanning-tree mst configuration
Parameters
none
Description
Use the SPANNING-TREE MST CONFIGURATION command to access
the MSTP mode from the Configuration Terminal mode. After you enter
this command, the prompt changes to “switch(config-mst) #” to indicate
the software has accessed the new mode.
To return to the Configuration Terminal mode, use the EXIT command.
Command Mode
Configuration Terminal Mode
Example
The following commands access the MSTP mode on the switch:
switch#configure terminal
switch(config)#spanning-tree mst configure
switch(config-mst)#
Related Commands
none