Allied Telesis AT-S83 - Manual (Page 198)

Chapter 9: Interface Configuration Mode Commands
198
STATIC-CHANNEL-GROUP
Syntax
static-channel-group channel-number <1-6>
no static-channel-group
Parameters
channel-number Specifies a channel number. Enter a value from 1 to 6.
Description
Use the STATIC-CHANNEL-GROUP command to add the interface to the
static aggregator with the specified key. If the aggregator does not exist, it
is created and the interface is added to it.
Use the no form of the STATIC-CHANNEL-GROUP command to detach
the port from the static aggregator. If the port is the last member to be
detached, the command deletes the static aggregator.
Command Mode
Interface mode
Example
The following commands set the channel number to 4 on interface 6:
switch#configure terminal
switch(config)#interface xe6
switch(config-if)#static-channel-group
channel-number 4
Related Commands
none