Allied Telesis AT-S83 - Manual (Page 244)

Chapter 13: Spanning Tree Protocol (STP) Commands
244
REGION REGION_NAME
Syntax
region REGION_NAME
no region
Parameters
REGION_NAME Specifies the name of the MSTP region.
Description
Use the REGION REGION_NAME command to specify the name of an
MSTP region on the switch.
Note
This command applies only to MSTP.
Command Mode
MST Configuration Terminal mode
Example
The following commands specify an MSTP region, called “mstp1,” on the
switch:
switch#configure terminal
switch(config)#spanning-tree mst configuration
switch(config-mst)# region mstp1
Related Commands
none