Allied Telesis AT-S83 - Manual (Page 259)

AT-S83 Management Software Command Line Interface User’s Guide
259
SPANNING-TREE MST ENABLE
Syntax
spanning-tree mst enable
no spanning-tree mst enable
Parameters
enable Specifies MSTP as the active spanning-tree protocol.
Description
Use the SPANNING-TREE MST command to enable MSTP on the switch.
After you have specified MSTP, all subsequent spanning tree commands
apply to MSTP. To make MSTP the active spanning tree mode and enable
it on the switch, use the SPANNING TREE MODE command.
Use the no form of this command to disable MSTP on the switch.
Command Mode
Configuration Terminal mode
Example
The following commands enable MSTP on the switch:
switch#configure terminal
switch(config)#spanning-tree mst enable
Related Commands
“SPANNING-TREE MODE” on page 257