Allied Telesis AT-S83 - Manual (Page 266)

Chapter 13: Spanning Tree Protocol (STP) Commands
266
SPANNING-TREE PRIORITY
Syntax
spanning-tree priority <0-61440>
no spanning-tree priority
Parameters
<0-61440> Specifies the bridge priority value in increments of 4,096.
For example, 4,096, 8,192, and 12,288 are all valid
values.
Description
Use the SPANNING-TREE PRIORITY command to specify the interface
priority. A lower priority value indicates a greater likelihood of becoming a
root. The default value is 32,768.
The no form of this command resets the spanning-tree priority value to the
default value which is 32,768.
Command Mode
Configuration Terminal mode
Example
The following commands set the spanning-tree priority on the switch:
switch#configure terminal
switch(config)#spanning-tree priority 4096
Related Commands
none