Allied Telesis AT-S83 - Manual (Page 176)

Chapter 9: Interface Configuration Mode Commands
176
FLOWCONTROL BACKPRESSURE
Syntax
flowcontrol backpressure on|off
Parameters
backpressure Specifies back-pressure flow-control in half-duplex mode.
Choose from the following options.
on Enables back pressure.
off Disables back pressure.
Description
Use the FLOWCONTROL BACKPRESSURE command to enable or
disable back-pressure flow-control on an interface.
Command Mode
Interface mode
Example
The following commands turns on back-pressure flow-control in half-
duplex mode on the 10/100/1000Base-T port:
switch#configure terminal
switch(config)#interface eth0
switch(config-if)#flowcontol backpressure on
Related Commands
none