Allied Telesis AT-S83 - Manual (Page 220)

Chapter 11: 802.1x Access Control Commands
220
DOT1X SYSTEM-AUTH-CTRL
Syntax
dot1x system-auth-ctrl
no dot1x system-auth-ctrl
Parameters
none
Description
Use the DOT1X SYSTEM-AUTH-CTRL command to enable global
interface authentication. To disable global authentication, use the no form
of this command. By default, global authentication is turned off.
Command Mode
Configure mode
Example
Use the following commands to enable global interface authentication on
the switch:
switch# configure terminal
switch(config)# dot1x system-auth-ctrl
Related Commands
none