Allied Telesis AT-S83 - Manual (Page 127)

AT-S83 Management Software Command Line Interface User’s Guide
127
LINE CONSOLE
Syntax
line console 0
Parameters
none
Description
The LINE CONSOLE command sets the console configuration and enters
the Line mode. The primary terminal line is set to line number 0. After you
enter this command, the prompt changes to indicate the Line mode.
For more information about the LINE mode, see Chapter 16, “Line Mode
Commands” on page 355.
Command Mode
Configuration Terminal Mode
Example
The following commands set the primary line console to 0:
switch#configure terminal
switch(config)#line console 0
switch(config-line)#
Related Commands
none