Allied Telesis AT-S83 - Manual (Page 162)

Chapter 8: Simple Network Management Protocol (SNMP) Commands
162
SNMP-SERVER ENGINEID LOCAL
Syntax
snmp-server engineid local ENGINEID-STRING
no snmp-server engineid local ENGINEID-STRING
Parameters
LOCAL Indicates a local copy of SNMP.
ENGINEID-STRING Indicates the engine ID. Choose a value of up to
24 characters.
Description
Use the SNMP-SERVER ENGINEID LOCAL command to specify the
switch’s engine ID on the local device. The AT-S83 software converts the
value to hexidecimal format automatically. By default, an SNMP engine ID
is generated automatically by the software. However, it is not displayed or
stored in the running configuration.
Use the no form of this command to remove the engine ID.
Command Mode
Configuration Terminal mode
Example
The following command configures an engine ID of 123456789:
switch#snmp-server engineid local 123456789
Related Commands
“SHOW RUNNING-CONFIG” on page 64