Allied Telesis AT-S83 - Manual (Page 18)

Chapter 1: Getting Started with the Command Line Interface
18
Table 2. Command Modes
Command
Mode
Prompt Description
View mode Switch# ˆ This is the default command mode for the
operator login.
ˆ Enter the LOGOUT or EXIT commands
to quit the software.
Privileged
Executive
mode Switch# ˆ This is the default command mode for the
manager login.
ˆ Access this mode from the View mode
with the ENABLE command.
ˆ Enter the DISABLE or EXIT commands
to return to the View mode.
Configuration
Terminal Mode Switch(config)# ˆ Use the CONFIGURE command to enter
this mode from the Privileged Executive
mode.
ˆ To return to the Privileged Executive
mode, enter the END or EXIT
commands.
Router Mode Switch(config-router)# ˆ Type the ROUTER RIP or ROUTER
OSPF commands to enter this mode from
the Configuration Terminal mode.
ˆ To return to the Configuration Terminal
mode, enter the END or EXIT
commands.
Interface
Configuration Switch(config-if)# ˆ To access interface 1, enter the following
from the Configuration Terminal Mode:
interface xe1
ˆ Enter the END or EXIT commands to
return to the Configuration Terminal
mode.
VLAN
Configuration Switch(config-vlan)# ˆ From the Configuration Terminal mode,
type the VLAN DATABASE command.
ˆ Enter the END or EXIT commands to
return to the Configuration Terminal
mode.