Allied Telesis AT-S83 - Manual (Page 300)

Chapter 14: Routing Information Protocol (RIP) Commands
300
SHOW IP PROTOCOLS RIP
Syntax
show ip protocols rip
Parameters
none
Description
Use the SHOW IP PROTOCOLS RIP command to display RIP process
parameters and statistics. To modify the lines displayed, use “|” the output
modifier token. To save the output to a file, use “>,” the output redirection
token.
Command Mode
View and Privileged Executive modes
Example
The following command displays RIP process parameters and statistics:
switch#show ip protocols rip
Routing Protocol is “rip”
Sending updates every 30 seconds with +/-50%, next due in 12
seconds
Timeout after 180 seconds, garbage collect after 120 seconds
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Default redistribution metric is 1
Redistributing: connected static
Default version control: send version 2, receive version 2
Interface Send Recv Key-chain
xe1
2 2
Routing for Networks:
10.10.0.0/24
Routing Information Sources:
Gateway
Distance Last Update BadPackets BadRoutes
Distance: default is 120
Related Commands
none