Allied Telesis AT-S83 - Manual (Page 304)

Chapter 14: Routing Information Protocol (RIP) Commands
304
SHOW IP RIP INTERFACE
Syntax
show ip rip interface IFNAME
Parameters
IFNAME Specifies the interface name. This is an optional parameter.
If you do not specify an interface to display, information
about all of the interfaces is displayed.
Description
Use the SHOW IP RIP INTERFACE command to display information
about the RIP interfaces. You can specify an interface name to display
information about a specific interface.
To modify the lines displayed, use “|” the output modifier token. To save
the output to a file, use “>,” the output redirection token.
Command Mode
View and Privileged Executive modes
Example
The following command displays the RIP interface information for all of the
interfaces:
switch#show ip rip interface
eth0 is down, line protocol is down
RIP is not enabled on this interface
eth1 is down, line protocol is down
RIP is not enabled on this interface
lo is down, line protocol is down
RIP is not enabled on this interface
vlan1 is down, line protocol is down
RIP is not enabled on this interface
xe1 is up, line protocol is up
RIP is enabled on this interface
xe2 is up, line protocol is up
RIP is enabled on this interface
xe3 is up, line protocol is up
RIP is enabled on this interface
xe4 is up, line protocol is up
RIP is enabled on this interface
xe5 is down, line protocol is down
RIP is not enabled on this interface