beautypg.com

Network – Allied Telesis AT-S83 User Manual

Page 290

background image

Chapter 14: Routing Information Protocol (RIP) Commands

290

NETWORK

Syntax

network A.B.C.D|IFNAME

no network A.B.C.D|IFNAME

Parameters

A.B.C.D/M

Specifies the IP address prefix and subnet mask.

IFNAME

Specifies an interface name with an alphanumeric string.

Description

Use the NETWORK command to specify networks to which routing
updates are sent to and received from. If a network is not specified, the
interfaces in that network are not advertised in any RIP update. The
default value is disabled.

Use the no form of this command to remove the specified network as one
that runs RIP.

Command Mode

Router mode

Example

The following commands permit interface 1 to send to and receive RIP
packets from network 10.0.0.0/8:

switch# configure terminal

switch(config)# router rip

switch(config-router)# network 10.0.0.0/8

switch(config-router)# network xe1

Related Commands

“CLEAR IP RIP ROUTE” on page 271, “SHOW IP RIP” on page 301