Allied Telesis AT-S83 - Manual (Page 294)

Chapter 14: Routing Information Protocol (RIP) Commands
294
RECV-BUFFER-SIZE
Syntax
recv-buffer-size <8192-2147483647>
no recv-buffer-size
Parameters
<8192-2147483647> Specifies the RIP UDP receive buffer size
value.
Description
Use the RECV-BUFFER-SIZE command to run-time configure the RIP
UDP receive-buffer size. The system default value is 8,192. Use the no
form of this command to remove the configured RIP UDP receive-buffer
size and return it to the default value.
Command Mode
Router mode
Example
The following commands set the RIP UDP receive-buffer size to
23,456,789:
switch# configure terminal
switch(config)# router rip
switch(config)# recv-buffer-size 23456789
Related Commands
none