Allied Telesis AT-S83 - Manual (Page 178)

Chapter 9: Interface Configuration Mode Commands
178
FLOWCONTROL SEND
Syntax
flowcontrol send on|off
Parameters
send Specifies IEEE 802.3x flow control to send messages.
Choose from the following options.
on Enables flowcontrol.
off Disables flowcontrol.
Description
Use the FLOWCONTROL SEND command to enable flow control to send
traffic on a specified interface. To disable flow control on the specified
interface, use the no form of this command.
Command Mode
Interface mode
Example
The following commands enable flowcontrol on interface 4:
switch#configure terminal
switch(config)#interface xe4
switch(config-if)#flowcontol send on
Related Commands
“FLOWCONTROL RECEIVE” on page 177