Allied Telesis AT-S83 - Manual (Page 125)

AT-S83 Management Software Command Line Interface User’s Guide
125
INTERFACE
Syntax
interface
Parameters
IFNAME Specifies the name of an interface.
Description
Use the INTERFACE command to access the Interface Configuration
command mode for the interface specified. After you enter the
INTERFACE command, “-if” is added to the prompt. For more information
about the commands included in the Interface mode, see Chapter 9,
“Interface Configuration Mode Commands” on page 171.
Command Mode
Configuration Terminal Mode
Examples
The following commands access the Interface mode on interface 3:
switch#configure terminal
switch(config)#interface xe3
switch(config-if)#
The following commands access the Interface mode on interface 8:
switch#configure terminal
switch(config)#interface xe8
switch(config-if)#
Related Commands
none