Allied Telesis AT-S83 - Manual (Page 156)

Chapter 8: Simple Network Management Protocol (SNMP) Commands
156
SNMP-SERVER COMMUNITY
Syntax
snmp-server community STRING view VIEWNAME ro|rw
no snmp-server community
Parameters
STRING Specifies the name of the SNMP community. Choose
an alphanumeric value between 1 and 255
characters. This name acts as a password and
permits access to SNMP.
VIEWNAME Indicates the name of a view that was defined with
the SNMP-SERVER VIEW command. Choose from
the following options:
ro Specifies the view is read-only access.
rw Specifies the view is read-write access.
Description
Use the SNMP-SERVER COMMUNITY command to set the name, view,
and access of an SNMP community.
Use the no form of this command to remove a community string.
Command Mode
Configuration Terminal mode
Example
The following command sets the name of the SNMP community to
“engineering 78” and the view to read-write access:
switch#snmp-server community “engineering 78” rw
Related Commands
“SNMP-SERVER GROUP” on page 163
“SNMP-SERVER VIEW” on page 170