Allied Telesis AT-S83 - Manual (Page 20)

Chapter 1: Getting Started with the Command Line Interface
20
View Command
Mode
The View command mode is the default command mode for the operator
login id. It permits access to basic commands. To indicate the View mode,
the prompt changes to “Switch>.” All of the commands in the View mode
are accessible from any of the other modes with the exception of the
ENABLE command.
See Table 3 on page 20 for a sample list of commands that can be
accessed from the View mode and a brief description of each command.
For more detailed information about the View mode commands, see
Chapter 4, “View Mode Commands” on page 45.
Table 3. View Mode Commands
Command Definition
CLEAR IP Clears the IP routing table and the stale kernel
route on the switch.
DEBUG DOT1X Turns on debugging is turned on for the 802.1x
protocol parameters.
ENABLE Changes the command mode from the View
mode to the Privilege Executive mode.
EXIT Exits the software from the View mode. From all
other modes, exits the current command mode
and returns to the previous mode.
LOGOUT Exits the software.
SHOW
RUNNING-
CONFIG Displays the current switch configuration.