Allied Telesis AT-S83 - Manual (Page 278)

Chapter 14: Routing Information Protocol (RIP) Commands
278
IP RIP AUTHENTICATION KEY-CHAIN
Syntax
ip rip authentication key-chain LINE
no ip rip authentication key-chain LINE
Parameters
LINE Specifies the name of the authentication key chain. Enter an
alphanumeric name. You do not have to use quotation marks
to specify spaces.
Description
Use the IP RIP AUTHENTICATION KEY-CHAIN command to perform
authentication on an interface and specify the name of the key chain. Not
configuring the key chain results in no authentication. Use the no form of
this command to disable this function.
Command Mode
Interface mode
Example
The following commands set the name of the key chain to “my key 1”on
interface 6:
switch#configure terminal
switch(config)#interface xe6
switch(config-if)#ip rip authentication key-chain my
key 1
Related Commands
“KEY” on page 286, “KEY CHAIN” on page 287, “IP RIP
AUTHENTICATION MODE” on page 279