Allied Telesis AT-S83 - Manual (Page 128)

Chapter 6: Configuration Terminal Mode Commands
128
LINE VTY
Syntax
line vty FIRST <0-15> LAST <0-15>
Parameters
FIRST Specifies the first line number. Enter a value between 0
and 15.
LAST Specifies the last line number. Enter a value between 0
and 15.
Description
Use the LINE VTY command to Telnet from the serial port to the RTM or
to any protocol daemon. This command is necessary for all Telnet
sessions. Before starting the daemon, add the value of the LINE VTY
command to the daemon’s configuration file.
After you enter the LINE VTY command, the prompt changes to indicate
the software has entered the Line mode. For more information about this
mode, see Chapter 16, “Line Mode Commands” on page 355.
Command Mode
Configuration Terminal mode
Example
The following commands shows the use of the LINE VTY command to
enter the Line mode:
switch#configure terminal
switch(config)#line vty 0 15
switch(config-line)#
Related Commands
“SHOW RUNNING-CONFIG” on page 64
“LINE CONSOLE” on page 127