Allied Telesis AT-S83 - Manual (Page 206)

Chapter 9: Interface Configuration Mode Commands
206
SWITCHPORT TRUNK ALLOWED VLAN
Syntax
switchport trunk allowed vlan
add|all|none|remove|except VLANID
no switchport trunk vlan
Parameters
add Add a VLAN to transmit and receive through the Layer-2
interface.
all Allow all VLANs to transmit and receive through the Layer-2
interface.
none Allow no VLANs to transmit and receive through the Layer-2
interface.
remove Remove a VLAN that transmits and receives through the
Layer-2 interface.
except All VLANs, except the VLAN for which the ID is specified, are
able to transmit and receive through the Layer 2 interface.
VLANID Specifies a VLAN ID or a list of VLAN IDs. Enter a value from 2
to 4094. Set a single VLAN, VLAN range, or a VLAN list.
For a VLAN range, specify the lowest VLAN, then the highest
VLAN number in the range, and separate them with a hyphen.
For a VLAN list, specify VLAN numbers separated by commas.
Note
Do not enter spaces between hyphens or commas when setting
parameters for VLAN ranges or lists.
Description
Use the SWITCHPORT ACCESS VLAN command to change the default
VLAN for an interface. Use the no form of this command to remove a
previously created VLAN with the specified VLAN ID.