Allied Telesis AT-S83 - Manual (Page 226)

Chapter 11: 802.1x Access Control Commands
226
RADIUS-SERVER DEADTIME
Syntax
radius-server deadtime <0-1440>
no radius-server timeout
Parameters
<0-1440> Indicates time in minutes. Choose a value between 0 and
1,440 minutes.
Description
Use the RADIUS-SERVER DEADTIME command to set the dead time
timer. There is no default value for this command. To remove the
configured value, use the no form of the command.
Command Mode
Configure mode
Example
The following commands set the dead time to 6 minutes:
switch# configure terminal
switch(config)# radius-server deadtime 6
Related Commands
none