Allied Telesis AT-S83 - Manual (Page 19)

AT-S83 Management Software Command Line Interface User’s Guide
19
In addition, there are commands that allow you to move between the
modes. For example, typing the EXIT command when you are in the
Interface Configuration mode returns you to the Configuration Terminal
mode. From the View mode, the LOGOUT command exits the software.
If you enter a command that is not accessible from a command mode, the
software displays a “command not found” message. For example, you can
enter the SHOW SNMP command from the Privileged Executive mode,
but you cannot enter this command from the VLAN Configuration mode.
Within the manual, a command mode is listed for each command.
See the following sections for a description of each command mode:
ˆ “View Command Mode” on page 20
ˆ “Privileged Executive Command Mode” on page 21
ˆ “Configuration Terminal Mode” on page 22
ˆ “Interface Configuration Command Mode” on page 22
ˆ “Router Mode” on page 24
ˆ “VLAN Configuration Command Mode” on page 24
ˆ “Line Mode Commands” on page 25
ˆ “Key Chain Mode Command” on page 26
Line Switch(config-line) ˆ From the Configuration Terminal mode,
type the LINE VTY command.
ˆ Enter the END or EXIT commands to
return to the Configuration Terminal
mode.
Key Chain Switch(config-
keychain)# ˆ To enter this mode from the Configuration
Terminal mode, type the KEY CHAIN
command.
ˆ Enter the END or EXIT commands to
return to the Configuration Terminal
mode.
Table 2. Command Modes (Continued)
Command
Mode
Prompt Description