beautypg.com

Snmp-server enable traps snmp – Allied Telesis AT-S83 User Manual

Page 161

background image

AT-S83 Management Software Command Line Interface User’s Guide

161

SNMP-SERVER ENABLE TRAPS SNMP

Syntax

snmp-server enable traps snmp link IFNAME

no snmp-server enable traps link IFNAME

Parameters

link

Enables link traps.

IFNAME

Specifies the name of the interface.

Description

Use the SNMP-SERVER ENABLE TRAPS SNMP command to enable
SNMP traps that are sent from a specified interface on the switch to a trap
host. If no interface is specified, this command enables SNMP traps on all
interfaces. Use the no form of this command to disable SNMP traps.

Command Mode

Configuration Terminal mode

Examples

The following command enables the SNMP link traps on interface 7:

switch#snmp-server enable traps snmp link xe7

The following command enables the SNMP link traps on all of the
interfaces:

switch#snmp-server enable traps snmp link

Related Commands

“SHOW RUNNING-CONFIG” on page 64

“SNMP-SERVER ENABLE TRAPS ENVIRON” on page 159

“SNMP-SERVER ENABLE” on page 158