Allied Telesis AT-S83 - Manual (Page 105)

105
Chapter 6
Configuration Terminal Mode
Commands
The commands in this chapter are accessed through the Configuration
Terminal mode. The commands in this mode allow you to configure
debugging, MAC addresses, and NTP commands.
This chapter contains the following commands:
ˆ “ACCESS-LIST” on page 107
ˆ “ARP” on page 109
ˆ “DEBUG OSPF EVENTS” on page 110
ˆ “DEBUG OSPF EVENTS” on page 110
ˆ “DEBUG OSPF IFSM” on page 112
ˆ “DEBUG OSPF LSA” on page 113
ˆ “DEBUG OSPF NFSM” on page 114
ˆ “DEBUG OSPF NSM” on page 115
ˆ “DEBUG OSPF PACKET” on page 116
ˆ “DEBUG OSPF ROUTE” on page 118
ˆ “DOT1X SYSTEM-AUTH-CTRL” on page 119
ˆ “DOT1X SYSTEM-AUTH-CTRL” on page 119
ˆ “ENABLE PASSWORD” on page 120
ˆ “ENABLE SECRET” on page 121
ˆ “EXIT” on page 122
ˆ “FIB RETAIN” on page 123
ˆ “HOSTNAME” on page 124
ˆ “INTERFACE” on page 125
ˆ “IP RADIUS SOURCE-INTERFACE” on page 126
ˆ “LINE CONSOLE” on page 127
ˆ “LINE VTY” on page 128
ˆ “LOG FILE” on page 129
ˆ “LOG TRAP” on page 130
ˆ “MAC ADDRESS-TABLE AGEING-TIME” on page 132
ˆ “MAC ADDRESS-TABLE STATIC DISCARD” on page 133
ˆ “MAC ADDRESS-TABLE STATIC FORWARD” on page 134