Allied Telesis AT-S83 - Manual (Page 208)

Chapter 9: Interface Configuration Mode Commands
208
SWITCHPORT TRUNK NATIVE
Syntax
switchport trunk native vlan VLANID
no switchport trunk native vlan VLANID
Parameters
VLANID Sets the ID of the VLAN.
Description
Use the SWITCHPORT TRUNK NATIVE command to set the native VLAN
for classifying untagged traffic through the Layer 2 interface.
Use the no form of this command to remove a native VLAN. By default, the
native VLAN shares the VLAN ID of 1 with the default VLAN.
Command Mode
Interface mode
Example
The following commands set the native VLAN to VLAN 2 on interface 5:
switch#configure terminal
switch(config)#interface xe5
switch(config-if)#switchport trunk native vlan 2
Related Commands
“SHOW VLAN” on page 361