Allied Telesis AT-S83 - Manual (Page 136)

Chapter 6: Configuration Terminal Mode Commands
136
NTP ACCESS-GROUP
Syntax
ntp access-group peer|query-only|serve|serve-only
Parameters
peer Provides full access to the switch.
query-only Provides query-only access to the switch.
serve Provides server and query access to the switch.
serve-only Provides server access to the switch.
Description
Use the NTP ACCESS-GROUP command to control the Network Time
Protocol (NTP) access to the switch. By setting the NTP commands, you
can permit the AT-S83 software to obtain the current date and time from
an NTP server located on your network or on the Internet.
Command Mode
Configuration Terminal mode
Example
The following commands permit NTP server access to the switch:
switch#configure terminal
switch(config)#ntp access-group serve-only
Related Commands
none