Allied Telesis AT-S83 - Manual (Page 214)

Chapter 11: 802.1x Access Control Commands
214
DOT1X MAX-REQ
Syntax
dot1x max-req <1-10>
no dot1x max-req
Parameters
<1-10> Indicates the maximum number of failed Extensible
Authentication Protocol (EAP) requests that are sent to the
supplicant. Choose a value between 1 and 10.
Description
Use the DOT1X MAX-REQ command to set the maximum number of
reauthentication attempts after authentication fails. Use the no form of this
command to reset the command to its default value. The default setting is
2 attempts.
Command Mode
Interface mode
Example
The following commands set the maximum number of reauthentication
attempts to 5 on interface 2:
switch# configure terminal
switch(config)# interface xe2
switch(config-if)# dot1x max-req 5
Related Commands
none