Allied Telesis AT-S83 - Manual (Page 245)

AT-S83 Management Software Command Line Interface User’s Guide
245
REVISION REVISION_NUMBER
Syntax
revision revision_number <0-255>
no revision revision_number
Parameters
none
Description
Use the REVISION REVISION_NUMBER command to specify the
revision number MSTP region on the switch.
Note
This command applies only to MSTP.
Command Mode
MST Configuration Terminal mode
Example
The following commands specify the MSTP revision number is 200:
switch#configure terminal
switch(config)#spanning-tree mst configuration
switch(config-mst)# revision 200
Related Commands
none