Allied Telesis AT-S83 - Manual (Page 23)

AT-S83 Management Software Command Line Interface User’s Guide
23
perform interface-specific commands on another interface, specify the
new interface in the Interface Configuration mode.
For a sample list of commands that can be accessed from the Interface
Configuration command mode, see Table 6. For more detailed information
about the commands in the Interface Configuration mode, see the
following chapters:
ˆ Chapter 9, “Interface Configuration Mode Commands” on page 171.
ˆ Chapter 10, “IP Interface Commands” on page 209
ˆ Chapter 11, “802.1x Access Control Commands” on page 213
ˆ Chapter 12, “Port Configuration” on page 239
ˆ Chapter 13, “Spanning Tree Protocol (STP) Commands” on page 243
Table 6. Interface Configuration Command Mode Commands
Commands Description
ARP-AGEING-
TIMEOUT Set a timer for ARP on a specific interface.
DOT1X MAX-
REQ Sets the maximum number of reauthentication
attempts after authentication fails.
FLOWCONTROL
ON Enables flow control and configures the flow
control mode for the interface.
IP ADDRESS Sets an IP address for the switch or specifies that
the switch uses a DHCP client to obtain an IP
address.
MAC-ADDRESS Sets the MAC address for a specified interface.
SHUTDOWN Disables an interface.
SPANNING-TREE
MODE Sets the active spanning tree protocol and enables
it on the switch.
SPEED Sets the speed and duplex mode for an interface.