IAI America SCON-CA - Manual (Page 290)

Chapter 10
Appendix
280
[4] Reset Circuit
If the “Stop” button on the operation box is pushed during pause, the “Reset” signal sent from
PLC to SCON is turned ON and the remaining moving distance is cancelled. In addition, this
operation releases the pause. (It is because the pause is not required with no remaining
moving distance.)
034
038
OUT3
OUT15
OUT2 IN15 OUT15
RES HOLDL
Pause
Display
RES
Reset
STOPL
RC Stop
Display
*ALM
* Alarm
Reset
a038
Waiting for Reset
b030
After 200 ms from reset input, the “Pause”
lamp goes off and the “Pause” signal is
turned OFF.
Thus, the reset signal remains ON for 200ms.
Due to no reset complete signal, pause
state is not cancelled until reset
processing is completed.
(Interlock)
Reset input is disabled because alarm
reset is generated while an alarm
occurs.
200ms is
set to
TIM1