Chapter 8 i/o parameter – IAI America SCON-CA User Manual
Page 203
Chapter 8 I/O Parameter
193
Chapter 8 I/O Parameter
Parameters are the data to set up considering the system and application.
When a change is required to the parameters, make sure to back up the data before the
change so the settings can be returned anytime.
With using PC software, it is able to store the backup to the PC. Leave a memo if using the
teaching pendant.
Also, for the purpose of rapid recovery after the investigation of failure unit or replacing the
controller, keep data backup or memo also after the parameter change.
The change to the parameters will be activated after they are edited, written to the flash FeRAM,
then either software reset or reboot of the power. It will not be active only with writing on the
teaching tool.
� �
Warning: Parameter setting has great influences on operations of the controller.
Incorrect parameter setting may not only cause malfunction or failure of the
controller to occur but also people and assets to be exposed to risk.
The controller is configured to be applicable to normal operation at shipment.
Before providing certain change or setting for the controller to be fit to your
system, understand the control methods of the controller sufficiently. Please
contact us if you have anything unclear.
Do not turn OFF the power to the controller during the parameter writing.