Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 79)

Global Configuration Commands
Features Management +WFM
©Restricted Page: 73 / 184
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 1 August 23, 2007
6.6.3 Parameters and Defined Values
: requested operation
0 disable feature
1 enable feature
2 get the feature state
If the parameter is not used, the status of all the
features are listed (with several +WFM responses).
: feature identification
The +WFM response only uses alphabetical values for the
parameter.
For values with two digits (like 1x, 6x or 8x), the
0 value is not "allowed". When a "xa" feature is enabled, enabling
another "xb" feature will automatically disable the "xa" feature.
numerical alphabetical
11 "MONO900" mono-band mode 900 MHz (default: 0)
12 "MONO1800" mono-band mode 1800 MHz (default:0)
13 "MONO1900" mono-band mode 1900 MHz (default:0)
14 "BI9001800" dual-band mode 900/1800 MHz
(default: 0)
15 "BI9001900" dual-band mode 900/1900 MHz
(default: 0)
16 "MONO850" mono-band mode 850 MHz (default: 0)
17 "BI8501900" dual-band mode 850/1900 MHz
(default: 0)
18 "QUADBAND" quad-band mode 850/900/1800/1900
MHz (default: 1)
2 "EFR" enhanced full rate feature (default: 1)
3 "HR" half rate feature (default: 1)
4 "DTXDATA" data with DTX feature (default: 1)
5 "DATA144" data 14.4 kbits/s feature (default: 1)
61 "SIM3VONLY" 3V SIM voltage mode (default: 0)
62 "SIM1V8ONLY" 1,8V SIM voltage mode (default: 0)
63 "SIM1V8AND3V" 1,8V and 3V SIM voltage mode
(default: 1)
7 "SIMREMOVE" SIM removal feature (default: 1)