Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) User Manual
Page 645

Battery Commands
Wavecom Battery Charge Management +WBCM
©Restricted
Page:
97 / 158
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001
VOLUME 4
August 23, 2007
23.2.4
Parameter Storage
All parameters except
using the AT&W.command The default value can be restored using AT&F.
23.2.5
Example
Command
Responses
AT+WBCM?
+WBCM: 0,0,4200,3500,100,5000,0,200
OK
Note: Current values (depend on ChargeMode
parameter); in this case, the charging mode is Ni-Cd/Ni-
MH
AT+WBCM=0
Note: Stop the battery charging
OK
AT+WBCM=4,0
Note: Configure the battery charging in Ni-Cd/Ni-
MH mode
OK
AT+WBCM=1,1
Note: Start the battery charging with charge
indications
OK
+WBCI: 2,4060
Note: Unsolicited charge indication: the current battery
voltage is 4.06 V.
AT+WBCM=1,1
Note: Start the battery charging with charge
indications on another port
+CME ERROR: 552
Note: The charge indications are already activated on
another port.
AT+WBCM=1,0
Note: Start the battery charging without charge
indications
OK
AT+WBCM=4,2
Note: Get the charging mode
+WBCM: 4,0
OK
Note: The charging mode is Ni-Cd/Ni-MH