Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 719)

APPENDIXES
Codes and Values
© Restricted
Page: 13 / 80
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 APPENDIXES August 23, 2007
All values other than specified should be treated as error #41.
1.7 Result Codes
Verbose result code Numeric (V0 set) Description
+CME ERROR: As verbose Error from GSM 07.05 commands
+CMS ERROR: As verbose Error from SMS commands (07.07)
BUSY 7 Busy signal detected
ERROR 4 Command not accepted
NO ANSWER 8 Connection completion timeout
NO CARRIER 3 Connection terminated
OK 0 Acknowledges correct execution of a command
line
RING 2 Incoming call signal from network
+COLP:, as verbose Outgoing Call Presentation
+CR: as verbose Outgoing Call report control
+ILRR: as verbose Local TA-TE data rate
CONNECT 300 10 Data connection at 300 bauds
CONNECT 1200 11 Data connection at 1200 bauds
CONNECT 1200/75 12 Data connection at 1200/75 bauds
CONNECT 2400 13 Data connection at 2400 bauds
CONNECT 4800 14 Data connection at 4800 bauds
CONNECT 9600 15 Data connection at 9600 bauds
CONNECT 14400 16 Data connection at 14400 bauds
+CSSI: [,] As verbose Supplementary service notification during a call
setup
1.8 GSM Sequences List
In accordance with GSM 02.30, the product supports the following GSM sequences,
which can be used through the ATD and the +CKPD commands.
1.8.1 Security
Change PIN code **04* OLDPIN * NEWPIN * NEWPIN #
Change PIN2 code **042* OLDPIN2 * NEWPIN2 * NEWPIN2 #
Unlock PIN code **05* PUK * NEWPIN * NEWPIN #
Unlock PIN2 code **052* PUK2 * NEWPIN2 * NEWPIN2 #
Show the IMEI number *#06#