Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 209)

GSM Network Commands
Wavecom Multi-band Selection Command +WMBS
©Restricted
Page: 19 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 2 August 23, 2007
11.4 Wavecom Multi-band Selection Command +WMBS
11.4.1 Description
This Wavecom proprietary command selects the GSM bands on which the Wireless
CPU ® has to operate. This command is allowed only if the selected bands are
supported (please refer to +WFM command). The user can choose if the change is
immediate or not:
• either the Wireless CPU ® has to be reset to take this change into account (this
is the default case)
• or the GSM stack restarts immediately on the specified band(s). In this mode,
the command +WMBS is forbidden during the initialization phase of the
Wireless CPU ® and during calls.
11.4.2 Syntax
Action command
AT+WMBS=[,]
OK
Read command
AT+WMBS?
+WMBS: ,
OK
Test command
AT+WMBS=?
+WMBS: (list of supported s),(list of supported s)
OK