Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 325)

GPRS Commands
Show PDP Address +CGPADDR
©Restricted
Page: 135 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 2 August 23, 2007
14.18.3 Parameters and Defined Values
:
PDP address: identifies the MT in the address space applicable
to the PDP
string type
The address may be static or dynamic. For a static address, it
will be the one set by the +CGDCONT command when the
context was defined.
For a dynamic address, it will be the one assigned during the
last PDP context activation that used the context definition
referred to by . is omitted if none is available.
: PDP context identifier
range: 1-4
integer type
If no is specified, the addresses for all defined contexts
are returned.
14.18.4 Parameter Storage
None.
14.18.5 Examples
Command Responses
AT+CGPADDR=? +CGAPDDR: (1,2,4)
OK
AT+CGPADDR=2 +CGPADDR=2,"10.3.73.151"
OK
AT+CGPADDR +CGPADDR: 1,
+CGPADDR: 2,"10.3.73.151"
+CGPADDR: 4,
OK
Note: Context 2 is active