Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 650)

Battery Commands
Wavecom Autodiag +WDIAG
©Restricted
Page: 102 / 158
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 4 August 23, 2007
: type of event
0 current value (not available in best effort mode)
1 ADC value is under the minimum threshold value ()
2 ADC value is above the minimum threshold value ()
(only after an unsolicited response with =1)
3 ADC value is under the maximum threshold value ()
4 ADC value is under the maximum threshold value ()
(only after an unsolicited response with =3)
5 The delta between two values among the last
values is more important than the delta threshold value
()
: ADC value in mV
range: 1-8000
for = 0: the current ADC value
for = 2: the minimum ADC value read while
the minimum threshold has been exceeded.
for = 4: the maximum ADC value read while
the maximum threshold has been exceeded.
for = 5: the delta ADC value read
23.3.4 Parameter Storage
The parameters are stored in EEPROM using the AT&W.command The default value
can be restored using AT&F.