Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) User Manual
Page 285
GPRS Commands
Define PDP Context +CGDCONT
©Restricted
Page:
95 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001
VOLUME 2
August 23, 2007
14.3.3
Parameters and Defined Values
PDP context identifier
range: 1-4
integer type
type of packet data protocol
"IP"
Internet Protocol (IETF STD 5)
"PPP"
Point to Point Protocol (IETF STD 51)
access point name: logical name that is used to select the GGSN
or the external packet data network.
string type
If the value is null or omitted, then the subscription value will be
requested.
PDP address: identifies the MT in the address space applicable
to the PDP
If the value is null or omitted, then a value may be provided by
the TE during the PDP startup procedure or a dynamic address
will be requested.
The read form of the command will return the null string even if
an address has been allocated during the PDP startup
procedure. The allocated address may be read using the
+CGPADDR command.
string type
PDP data compression mode
0
OFF
(default
value)
1
ON
PDP header compression mode
0
OFF
(default
value)
1
ON
14.3.4
Parameter Storage
The parameters are stored in EEPROM without using the AT&W command.