Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 163)

Serial Port Commands
Multi-flow Management +WMFM
©Restricted Page: 157 / 184
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 1 August 23, 2007
8.12.3 Parameters and Defined Values
: managing mode
0 manage active physical ports
1 manage incoming data
: requested operation according to :
0 close physical port
or
set dynamic mode for incoming data (data direction is set
on ATD / ATA commands for GSM, or ATD / +CGDATA
commands for GPRS)
1 open physical port
or
attach incoming data to
2 read state
3 Internal use
: port identifier
1 UART1
1x DLC x on UART 1 (x : from 1 to 4)
2 UART2
2x DLC x on UART 2 (x : from 1 to 4)
3 USB
3x DLC x on USB (x: from 1 to 4)
4 dynamic port (only in read mode, default value with
=1)
80 Open AT ® application
Test command
AT+WMFM=?
+WMFM: ,(list of supported s),(list of
supported s)[,(list of supported s)]
[+WMFM: ,(list of supported s),(list of
supported s)[,(list of supported s)][…]]
OK